- Zhejiang Marui Power Machinery Co.,Ltd
- TEL: +86-577-65396111
- E-mail: firstname.lastname@example.org
- Phone: +8613567762679
1. Check cylinder bore
Measured with the internal diameter dial indicator (or dial gauge), in the direction of the piston pin and its vertical direction, select the upper, middle, and lower three segments of the cylinder to determine the inner diameter, which maximum value as the cylinder diameter value. If this value has exceeded the limit, honing or replacing the new cylinder should be carried out.
2. Check cylinder end face deformation
Check the end face of the cylinder with a ruler and thick gauge (Caution: Clean the liner and adhesive marks). If the deformation is greater than the limit of use, it should be ground or replaced.